A refrigerator ice maker freezes water and keeps it. A standalone undercounter ice machine is different: it melts and discards water constantly. Clear-ice models rinse minerals away during each batch, and the storage bin slowly melts because most of these units do not hold ice frozen like a freezer does. All of that water needs somewhere to go, every hour of every day.
That is why the drain is the first thing to plan, not the last.
Two kinds of drainage
Gravity drain
The water simply flows downhill from the unit's drain outlet to a floor drain, standpipe or other receptor. This works only if the receptor is lower than the outlet on the back of the machine, and the line can slope steadily downward the whole way. Many manuals call for a continuous fall over the run; a quarter inch per foot is a common figure, but check your model.
Pumped drain
A small condensate-style pump, either built in or added as a kit, lifts the water up and over to a drain that sits higher than the unit, often the sink drain. Many manufacturers sell a pump version of the same ice maker for this reason.
Deciding which you need
Ask three questions:
- Is there a drain lower than the ice maker's outlet? Kitchen islands and wet bars often have nothing lower than the sink trap, which sits above the unit's drain.
- Can the line run without rising? Even a short uphill section will hold water and cause backups.
- How far is the run? Long horizontal gravity runs need more drop, and every foot is a chance for a sag.
Finished basement bars are a common case in Columbus-area homes. The floor drain might be across the room by the furnace, and the bar sink sits higher than the ice maker. In that setup a pump model usually makes more sense than tearing up the floor.
Requirements that apply either way
- •Indirect connection. Ice makers handle food, so their drains are generally connected to the building drain indirectly, through an air gap or air break, rather than plumbed tight into a waste pipe. That keeps sewer water from ever backing into the ice bin. Your manual and local plumbing code will specify the method.
- •A vented, trapped receptor. The drain the ice maker empties into should be properly trapped and vented, so sewer gas stays out of the room.
- •Hose size and type. Manuals usually specify a minimum inside diameter. Do not neck down to a smaller tube to make a fitting work.
- •No sags or loops in gravity lines. A low spot collects water and slime and eventually clogs.
- •Freeze protection. Lines running through an unheated crawlspace or along an exterior wall can freeze in a central Ohio winter. Route them through conditioned space.
Common installation mistakes
- •Connecting the drain tube directly into a sink tailpiece with no air gap.
- •Running a gravity drain with a slight uphill section hidden inside the cabinet.
- •Kinking the soft drain hose when pushing the unit into its opening.
- •Choosing a gravity model for a location that can only drain upward.
- •Forgetting that a pump needs its own power and can fail; some pump kits have an alarm or shut-off switch.
Maintenance that keeps the drain flowing
Ice machines are especially sensitive to hard water. Scale and biofilm build up in the drain path as well as on the evaporator. Follow the manufacturer's cleaning and descaling schedule, and clean the drain line when you clean the machine. If a pump is in the system, check its reservoir for slime at the same time.
Water supply matters too; if the inlet pressure is low, production drops. Our post on checking household water pressure explains how.
When it backs up or leaks
Water pooling under the unit, a bin that fills with water instead of ice, or a pump that runs constantly all point to a drain or pump problem, sometimes combined with a scaled-up machine. Our undercounter ice machine service team works on undercounter units from many brands, including Sub-Zero, and will explain what we find before any work starts. Book online when it is convenient.