Call or book
Dryer

How Long Can a Dryer Vent Be? Counting Feet and Elbows

Every elbow shortens how far a dryer can push air. Learn how code and manuals set dryer vent maximum length, and how to measure your own run from dryer to hood.

TrueFix Columbus5 min read

A dryer's blower is sized to push air through a certain amount of duct. Go past that and the dryer still runs, but moisture and lint linger in the pipe instead of leaving the house. Two documents set the limit: the building code and the dryer's own installation manual.

The code's default number

Ohio homes fall under the Residential Code of Ohio, which is based on the International Residential Code. The IRC sets a default maximum developed length of 35 feet for a 4-inch dryer exhaust duct, measured from the dryer connection to the outside termination. Fittings count against that:

FittingLength deducted (IRC default)
45-degree elbow2.5 feet
90-degree elbow5 feet

The code also allows a longer run when the dryer manufacturer's installation instructions permit it, provided the dryer model is known and the instructions are available to the inspector. Some manuals allow longer runs than 35 feet with a given number of elbows, and some "long vent" models go further still. If you replace the dryer later, the new model has to be rated for the same run, so check its manual before you buy.

What the duct itself must be

  • •Material: Rigid metal with a smooth interior, 4 inches in diameter unless the manual says otherwise. No plastic or foil.
  • •Joints: Joined so the inside stays smooth. Screws or rivets that poke into the airstream catch lint.
  • •Transition duct: The short connector behind the dryer should be a listed transition duct, kept short and in the open. It may not run through walls or ceilings.
  • •Termination: Outside the building, with a backdraft damper and no screen, which would clog with lint.

Measuring your run

  1. Start at the dryer's exhaust outlet. Follow the duct to the hood outside, through joists, walls or up through the house.
  2. Measure every straight section, including vertical rises.
  3. Count each elbow and note whether it is 45 or 90 degrees. Do not forget the elbow right behind the dryer.
  4. Add the deductions to the straight footage to get the equivalent length.
  5. Compare the total with your manual's chart, or with the code default if the manual is unavailable.
  6. Step outside and run the dryer. The hood flap should open fully and you should feel strong airflow.

Central Ohio layouts to watch

Many older Columbus homes have basement laundry, and the vent may climb to a rim joist or cross the basement to reach an outside wall. That can add both length and elbows quickly. Mid-century ranches often vent straight out, which is usually short. Second-floor laundry rooms in newer subdivisions sometimes vent through the roof, which adds vertical rise and a roof cap that collects lint at the top.

Signs your vent is too long or partly blocked

  • •Loads need extra time or a second cycle.
  • •The laundry room gets humid and warm.
  • •The top of the dryer is hot to the touch.
  • •Lint shows up around the outside hood or the dryer door.
  • •The dryer shuts off mid-cycle or a thermal fuse blows.

A long run also collects lint faster, so it needs cleaning more often. Lint in a duct is a fire risk, so do not ignore these signs.

Fixing an over-length vent

Options include rerouting to a closer outside wall, replacing 90-degree elbows with gentler 45-degree pairs where space allows, swapping flexible sections for rigid duct, or choosing a dryer rated for a longer run. Cutting a new wall or roof opening is work for a contractor, and moving a gas dryer to shorten a run means a licensed plumber or gas fitter has to reconnect it. If the dryer is in a closet, airflow into the closet matters too; see our notes on airflow in laundry closets.

When the vent checks out and clothes still come out damp, the problem is inside the dryer. Our technicians test the heating circuit, sensors and blower, then explain the repair and the price before starting. Schedule a visit through the dryer repair service page.

Want a Technician to Look at It?

We diagnose in your Columbus-area home and agree on the price before any repair begins.

More From Our Blog

CallBook