Stacking puts a dryer full of wet towels on top of a machine that spins at high speed. The only thing tying the two together is a small set of brackets, so manufacturers are specific about when stacking is allowed. If you are short on floor space in a Short North condo or a basement corner in an older Clintonville house, the questions below will tell you whether your pair can go vertical.
Start with the model numbers, not the cabinets
Two machines that look alike may not stack. The stack kit is designed around mounting points on particular cabinet families, and each manufacturer lists the approved kit by part number in the washer's and dryer's installation manuals.
- Copy the full model number from the label on each machine, usually inside the door or on the back.
- Look up the stacking section in each manual and find the kit part number it names.
- If both manuals name the same kit, you have a matched pair. If one manual is silent or names a different kit, treat the pair as not stackable.
- Do not mix brands, and do not assume a kit from one product line fits a newer or older line from the same brand.
Most full-size stackable pairs are 27-inch front-loaders. Compact 24-inch pairs have their own kits. A top-loading washer can never carry a dryer, because its lid is the only way in.
Floor, feet and level
The washer becomes the foundation for both machines once the dryer is on top. That changes a few setup rules.
- •On the floor, not a pedestal: Many stack kit instructions say the stacked pair must sit directly on the floor. A pedestal raises the center of gravity and amplifies shaking at the top.
- •All four feet down: Level the washer side to side and front to back, then tighten the lock nuts so the feet cannot creep.
- •Solid floor: A springy floor lets the stack sway during spin. Old joists in a converted attic or upper-floor laundry deserve a look before stacking. Our post on floors for front-load washers goes deeper on what belongs underneath.
- •Shipping bolts out: Both machines ship with transit hardware that has to come out before use.
Height and the things that move up with the dryer
A stacked dryer's connections end up far higher than they would beside the washer. Measure before you buy a kit.
- •Ceiling or closet height: The manual gives the overall stacked height. Add room above for the vent connection and for sliding the dryer out later.
- •Dryer outlet: An electric dryer's 240-volt cord usually comes off the upper back, so the receptacle may need to move up. A gas dryer's connector and shutoff valve need to reach as well.
- •Vent path: The exhaust now leaves high on the back. Plan a short, smooth run without crushing the transition duct against the wall.
- •Controls: Shorter household members should be able to reach the dryer controls and lint screen comfortably.
Signs a stack is not set up right
- •The dryer walks or knocks during the washer's spin.
- •The kit brackets show gaps, or the dryer overhangs the back more than the instructions allow.
- •The vent hose is kinked behind the stack.
- •A plug sits stretched tight between the outlet and the dryer.
Any of these is worth fixing before the next load. A dryer that loses heat after being stacked often has a crushed vent rather than a failed part, though both are possible.
Who handles which part
Fitting a matched stack kit and leveling the pair is mechanical work a careful owner or appliance technician can do. Moving a 240-volt receptacle is a job for a licensed electrician. Reconnecting a gas dryer at a new height belongs to a licensed plumber or gas fitter. Closets bring their own airflow rules, explained in our guide to closet laundry airflow and spacing.
If your stacked pair is shaking, not heating or throwing error codes, our technicians can diagnose both machines and quote the repair before any work begins. You can book a visit through our washer repair page.