In central Ohio, the water that reaches a washer is rarely a river. It is a spring storm on top of saturated ground, a quick snowmelt, a floor drain backing up, or a sump pump that quit when the power went out. Basement laundry is common in older Columbus neighborhoods, so a few inches of water on the floor can put a washer, dryer and water heater out of service at once. Raising equipment, even modestly, is one of the cheapest ways to protect it.
Where basement water comes from here
- •Heavy rain and snowmelt: Water moves through the soil and in through foundation cracks, wall-floor joints and window wells.
- •Sump pump problems: A stuck float switch, a worn pump, a frozen or clogged discharge line, or a power outage during a storm.
- •Drain backups: Floor drains and laundry drains can back up when municipal or private lines are overwhelmed or partly blocked.
- •Plumbing failures: A burst washer hose or a leaking water heater can cover the floor just as well as a storm.
- •Floodplains: Some properties near the Scioto, the Olentangy and their tributaries sit in mapped flood zones. If yours does, check the FEMA flood map and talk to your community's floodplain administrator about the expected flood elevation.
What appliance manuals say
Washer and dryer installation manuals generally say not to install or store the machine in a spot where it can get wet or be left out in the elements. They do not give a flood height, because that depends on your house. The practical goal is to keep each appliance's base, motor, controls and electrical connections above the highest water your basement is likely to see.
How to raise basement laundry
- Find your water line. Look for stains or tide marks on walls, the bottoms of stored boxes, and the history of the house. If you are unsure, plan for more height rather than less.
- Pick a platform. Options include a poured or masonry block platform, a sturdy built platform rated for a running washer's weight and vibration, or manufacturer pedestals. A front-load washer on a wobbly platform will shake itself loose, so the base must be solid and level.
- Check the stack. If you raise a stacked pair, confirm the stack kit allows it. Many do not allow pedestals. See our stacking kit guide.
- Move connections with the machine. The receptacle, gas shutoff, water valves and dryer vent should all end up above the water line and within reach of the raised appliance.
- Keep clearances. Measure ceiling height, joists and ductwork overhead so you can still open the lid and pull the machines out.
Protection that costs little
- •A washer drain pan, piped to a floor drain where possible.
- •A battery-powered water alarm on the floor beside the washer and another near the sump.
- •A backup for the sump pump, such as a battery backup system.
- •Steel-braided or reinforced fill hoses in place of rubber ones.
- •Receptacles above the expected water line. Basement receptacles generally need GFCI protection under current electrical code.
If water reaches the appliances
- •Do not walk into a wet basement if the water may be touching outlets, cords or appliances. Shut off power at the main panel only if you can reach it from a dry spot. Otherwise, call your electric utility.
- •Do not run any appliance that was sitting in water until it has been checked. Motors, control boards and wiring are not sealed against submersion.
- •Gas controls and valves that have been underwater should be replaced, not dried out and reused. Have a qualified technician or licensed plumber inspect any gas appliance before relighting it.
- •An electrician should inspect submerged wiring and receptacles before power goes back on to that area.
When to call the trades
Moving receptacles or circuits is work for a licensed electrician. Moving water lines, drains or adding a backwater valve is plumbing work. Relocating gas appliances such as a dryer or water heater calls for a licensed plumber or gas fitter. Work in a mapped floodplain may need a permit and an elevation that meets local floodplain rules.
After the water is gone, our technicians can evaluate washers, dryers and other basement appliances, tell you honestly whether a repair makes sense, and give you a price before any work. Start with our washer repair page, or see the full list of neighborhoods on our service areas page.