Call or book
Microwave

Hanging an Over-the-Range Microwave: Heights, Studs and Power

An over-the-range microwave depends on cabinet height, cooktop clearance, a wall stud and an outlet in the cabinet above. Learn the measurements to check first.

TrueFix Columbus4 min read

An over-the-range microwave does two jobs: it heats food and it serves as a range hood. It also hangs over a hot cooking surface from a wall plate and the cabinet above. That combination is why the installation manual is strict about its position. Before buying one, a few measurements tell you whether your kitchen can take it.

The two height measurements

Over-the-range microwave manuals set position mainly through the cabinet above it:

  • •Floor to cabinet bottom: Many manuals want the underside of the upper cabinet 66 inches or more above the floor.
  • •Cooking surface to cabinet bottom: Many manuals also require at least 30 inches between the cooking surface and the bottom of that cabinet.

The microwave hangs below the cabinet, so these two figures together decide how far its underside sits above the burners. The manual for your model may also list a minimum gap between the microwave and the top of the range backsplash or control panel.

Width and support

  • •Opening width: Most over-the-range microwaves fit a 30-inch opening between cabinets. Some manuals allow wider openings with filler kits.
  • •Wall plate and stud: The microwave hangs from a mounting plate on the wall, which must be fastened into at least one wall stud. The manual lists required wall construction.
  • •Top bolts: Bolts through the cabinet floor above carry the front of the unit. The cabinet must be sturdy enough to support it.
  • •Load: The mounting must hold the microwave plus the food and cookware inside. Drywall anchors alone are not enough.
  • •Islands: Over-the-range microwaves are made for wall installation, not islands or peninsulas.

Power

Most manuals call for a grounded receptacle inside the cabinet above the microwave, on a separate circuit, commonly 15 or 20 amps. The cord passes up through a hole in the cabinet floor. A receptacle behind the range or on the backsplash is not a substitute, and an extension cord is not acceptable.

Venting choices

Over-the-range microwaves can usually be set up three ways: vented outside through the top, vented outside through the back, or recirculating through a charcoal filter. Exterior venting usually connects to a standard 3 1/4-by-10-inch rectangular duct, or to round duct through a transition. If you are venting outside, the duct run and cap matter as much as the fan; see choosing hood duct size and length.

Measure before you buy

  1. Floor to cabinet: tape from the floor up to the underside of the cabinet that will sit over the microwave.
  2. Cooktop to cabinet: tape from the grates or glass up to that same underside.
  3. Measure the width of the opening.
  4. Find and mark the studs behind the opening.
  5. Check inside the upper cabinet for a receptacle.
  6. Look for an existing duct opening in the wall or cabinet top, and note its position.

If the cabinet is too low, it may need to be raised or replaced with a shorter one. That is common in older kitchens where the cabinet over the range was built for a hood.

Common installation problems

  • •The microwave mounted too low, so its underside gets hot and the controls are hard to read over steam.
  • •A wall plate fastened only to drywall that starts to sag.
  • •Vent damper taped shut or the duct never connected, so grease and steam collect.
  • •Charcoal filters left out in recirculating mode.

Who does what

Adding the receptacle and circuit in the upper cabinet is work for a licensed electrician. Any new opening in an exterior wall or the roof for the duct is a contractor's job. Never open a microwave's outer case: it contains high-voltage components, including a capacitor that can hold a dangerous charge after the unit is unplugged.

If your over-the-range microwave stops heating, has a fan or light failure, or trips its breaker, our microwave repair technicians can diagnose it in place and quote the repair before any work. We service GE, Whirlpool, Samsung, LG and other major brands.

Want a Technician to Look at It?

We diagnose in your Columbus-area home and agree on the price before any repair begins.

More From Our Blog

CallBook