Most central Ohio homes keep laundry in a basement or a first- or second-floor laundry room, but some owners move machines into the garage during a remodel, or rent a home where the hookups are already there. That works in July. In January, after a few nights well below freezing, an unheated garage can damage a washer in ways that do not show up until spring.
Why cold hurts a washer
A washer never fully drains. Water stays in the inlet valve, the pump, the hoses and the bottom of the tub. When that water freezes, it expands, and the parts holding it are mostly plastic. A cracked inlet valve or pump housing can leak the next time the water is turned on, sometimes slowly enough that nobody notices until the floor is wet.
Washer installation manuals address this directly. They generally say not to install, store or operate the washer where it will be exposed to freezing temperatures or the weather. Supply pipes on garage walls are also at risk, since they often run along an exterior wall.
Why cold affects a dryer differently
A dryer does not hold water, so freezing is not the issue. The problem is performance and control. Some dryer manuals set a minimum room temperature for operation, often around 45°F. Below that, automatic dry cycles that sense moisture may not shut off when expected, and drying times stretch. A dryer can be out of its operating range even when the garage stays above freezing.
Other garage-specific rules
- •Floor slope: Garage slabs slope toward the door for drainage. Dryer and washer manuals list how much slope the feet can handle; beyond that, you need a leveling kit or a level platform.
- •Gas dryers: Codes based on the IRC generally require an appliance with an ignition source in a garage to be raised at least 18 inches off the floor, unless it is listed as resistant to flammable vapor ignition.
- •Code restrictions: Some manuals note that local code may restrict dryers in garages. Check with your building department before moving laundry there.
- •Venting: The dryer still has to vent outdoors, not into the garage.
A winter check for garage laundry
- Place a thermometer that records minimum temperatures near the machines and read it after a cold night.
- Compare the low with the washer's freezing limit and the dryer's minimum operating temperature from each manual.
- Follow the hot and cold supply pipes back toward the house. Pipes on exterior walls freeze first.
- Check level across the washer and dryer with a carpenter's level.
- For gas dryers, measure the burner height above the floor.
Winterizing a washer that will sit unused
If the garage will freeze and the washer will not run until spring, follow the winterizing steps in the manual. They usually involve shutting off both faucets, disconnecting and draining the fill hoses, and running a short cycle or a drain step. Some manuals describe adding RV antifreeze to protect the pump, followed by a full rinse cycle before the next use. Unplug the machine afterward.
After a cold snap
If a washer will not fill, or leaks after a freeze, turn the water off at the valves and let the garage warm before running it again. A cracked valve or pump needs replacement, not thawing. Our washer repair technicians can check for freeze damage and quote the repair before any work.
Better options
Insulating and heating a garage, or moving the laundry indoors, are the reliable fixes. Rerouting water lines is plumbing work, a garage heater circuit needs a licensed electrician, and gas dryer moves need a licensed plumber or gas fitter. If your basement is the alternative, read about keeping basement laundry dry in our post on raising appliances above basement water.
A dryer that runs endlessly in a cold space may also have a sensor or thermostat issue worth checking once it is back in a heated room. You can schedule a visit through our dryer repair page.