Hobart Dishwasher
Hobart Commercial Dishmachine Repair
A Hobart dishmachine that goes down during a rush turns into a stack of dirty plates, a slowed line and, if the final rinse is not hot enough, a health inspection problem. Hobart is a commercial foodservice equipment maker within ITW Food Equipment Group, best known for dishmachines and mixers, and its machines are built for heavy daily use.
Prefer not to call? The form takes about a minute.
We try to schedule around your service, and a written summary of the fault and the fix is available for your files or your inspector. When cleaning or upkeep is the real cause, you hear that from us instead of a parts quote.
Cool final rinse: check three things together
High-temperature Hobart machines rely on a booster heater to bring the final rinse up to sanitizing temperature. When the rinse runs cool, we check the booster element, its thermostat and the temperature of the water coming in from the building, all together. A booster can only raise water so much, so a tired water heater or a long supply run can be the real cause even with a healthy booster. Scale on the booster element, common with central Ohio's moderately hard water, slows heating too.
If your machine uses chemical sanitizing instead, a weak or empty sanitizer supply, or a dispensing pump that has stopped, causes the equivalent problem.
Machine will not run
Hobart door-type dishmachines start the cycle when the door closes. A machine that will not run often needs its door switch or the linkage that operates it adjusted, not a new controller. Doors take a beating in a busy dish room, and a slight misalignment is enough to keep the switch from making contact.
Wash quality and other faults
- Food left on wares: clogged scrap screens, blocked wash or rinse arm nozzles, or a wash tank that needs draining and refilling more often.
- Spotting or film: scale on arms and nozzles, or detergent and rinse-aid dispensing out of adjustment.
- Tank not heating: tank heater element, its thermostat or a low-water safety that thinks the tank is empty.
- Water around the machine: door gaskets, curtains on larger machines, or a drain valve not closing.
Daily and weekly habits
Pull and clean the scrap screens and wash arms at the end of each day, drain the tank, leave the doors open to dry, and delime on the schedule your water calls for. Columbus water is hard enough that skipped deliming shows up as slower heating and spotty wares within weeks. Hobart also makes mixers and slicers, and their wear parts, such as transmission gears, planetary seals and slicer sharpening assemblies, are routine rebuilds if those need attention on the same visit.
Hobart Dishwasher Repair Questions
Straight answers to what Columbus homeowners usually ask before booking. If your question is not here, send it with your booking request and we will answer it.
Still have questions?
Reach us by phone or book online. We cover Columbus and nearby communities in Franklin, Delaware, Fairfield, Licking, Union, Madison and Pickaway counties.
Maybe, but we check the booster element, its thermostat and your incoming water temperature together. Any one of the three can cause a cool rinse.
The door switch or its linkage is often out of adjustment. That is a much smaller repair than a controller.
It depends on your water and volume. With moderately hard water and heavy use, more frequent deliming keeps heaters and nozzles working.
Yes. We can document what we found and what we fixed for your records or for an inspector.
Dishwasher problems in general
Faults any brand can have, the symptom most often misread, and safe checks to try first