Dishwashers combine water, a heating element, a pump and electronics in one cabinet, so manufacturers are specific about how they get power. The requirement itself is straightforward. What varies is how your kitchen is wired and whether the new dishwasher arrives ready for that wiring.
What the dishwasher needs
Most residential dishwashers in the U.S. are designed for:
- •A 120 volt, 60 hertz supply.
- •A 15 or 20 amp circuit, as specified on the model's rating label and in its manual.
- •A proper equipment ground.
- •Usually, a circuit dedicated to the dishwasher or shared only in ways the manual and code allow.
The heating element is the main load, which is why manufacturers want a circuit that is not also feeding countertop appliances.
Two ways to connect
Hardwired
The house cable comes into a small junction box on the dishwasher, usually behind the lower kick panel. The supply wires are connected to the dishwasher's leads inside that box. There is no plug. Many older installations are hardwired.
Plug-in
A cord with a three-prong plug runs from the dishwasher's junction box to a receptacle in the sink cabinet. This makes future service and replacement simpler, since power can be disconnected by unplugging.
Some dishwashers ship with a cord already attached. Many do not, and the manufacturer sells a power cord kit made for that model. Use the kit the manual specifies rather than a generic appliance cord.
Which one your kitchen has
Open the sink cabinet and look:
- •A receptacle in the cabinet usually means the old dishwasher was plugged in.
- •No receptacle, and a cable running through the cabinet floor or wall toward the dishwasher usually means it was hardwired.
- •A receptacle that also feeds the disposer means you should check whether the circuit can handle both loads.
Older kitchens
In older Columbus homes, especially ones where a dishwasher was added years after the house was built, it is common to find a dishwasher on a circuit shared with the disposer, the kitchen lights or even a neighboring room. You may also find old cable without a ground conductor.
Those situations do not always mean something is unsafe, but they are worth having a licensed electrician check before installing a new machine. Replacing a dishwasher is a good moment to make the circuit right.
GFCI and AFCI protection
Ohio builds homes under the Residential Code of Ohio, which is based on the International Residential Code, and electrical work follows the electrical code adopted with it. Recent code editions have expanded ground-fault protection to include dishwasher outlets and branch circuits in many cases, and arc-fault protection for kitchen circuits is common in newer work. What applies to your kitchen depends on when the work is permitted and how your local inspector reads it.
A dishwasher on a GFCI that trips repeatedly is telling you something. It can point to a fault in the dishwasher, such as a leaking heater or pump, so do not remove protection just to stop the trips.
Safety steps for any dishwasher work
- Turn off the circuit at the breaker, not just the wall switch some dishwashers have.
- Confirm power is off with a non-contact tester at the junction box.
- Keep wire connections inside the junction box with its cover on.
- Use a strain relief where the cable or cord enters the box.
- Never splice a cord to house wiring outside a junction box.
After installation
If a new dishwasher trips the breaker, will not power on, or shows a control error right away, check the connection first, then the machine. Our dishwasher repair technicians handle those diagnoses on site; book online if you need one. For the rest of the installation picture, see measuring the opening for a new dishwasher and our guide to routing the drain hose.