Call or book
Dishwasher

High Loop or Air Gap: Routing a Dishwasher Drain Hose

How a dishwasher high loop and a countertop air gap each keep sink water out of the tub, when local code may require an air gap, and how to check your setup.

TrueFix Columbus4 min read

Under every kitchen sink with a dishwasher, the drain hose has the same job: carry dirty water away and never let it come back. There are two common ways to make sure of the second part, and which one your kitchen uses depends partly on preference and partly on what your local plumbing inspector expects.

The problem both methods solve

A dishwasher drain hose connects to the same plumbing as your sink. If the kitchen drain clogs, or the disposer is full of food when the dishwasher pumps out, wastewater can try to flow the wrong way, back into the dishwasher tub. A hose lying low can also siphon, slowly pulling water out of the dishwasher during a cycle.

Option one: the high loop

The drain hose is routed up as high as possible inside the sink cabinet, usually fastened to the underside of the countertop or the back of the cabinet, before it drops down to the disposer or waste tee.

How it helps: water would have to rise above that loop to flow back into the dishwasher, and the elevated hose discourages siphoning.

What it does not do: it does not physically separate the dishwasher from the drain. In a severe backup, dirty water can still find its way in.

Most dishwasher manuals describe a minimum height for the loop, measured from the floor. Your model's manual gives the exact figure.

Option two: the air gap

An air gap is a small fitting mounted on the sink deck or countertop, usually with a chrome cap. The dishwasher hose runs up to it, and a second hose runs from it down to the drain. Inside, the water falls through open air before entering the drain side.

How it helps: there is a true physical break. Wastewater cannot travel back into the dishwasher, because there is no continuous path.

The trade-offs: it needs a hole in the sink or counter, it is visible, and if the drain side clogs, water spills out of the cap onto the counter. That spill is the device doing its job, not failing.

Which one does code require?

It depends on where you live. Ohio's residential construction follows the Residential Code of Ohio, which is based on the IRC, and plumbing requirements are enforced locally. Some jurisdictions require an air gap for dishwashers, while others accept a high loop. If you are doing a remodel with a permit, ask your building department or plumber what the local inspector expects. If you are simply replacing a dishwasher, match what is already there unless it is clearly wrong.

Common mistakes we see

  • •The hose lying flat on the cabinet floor. No loop at all. This is the most common problem.
  • •A loop that has sagged. It was clipped up once, the clip broke, and now it hangs halfway down.
  • •A new disposer with the knockout plug still in. A new disposer comes with its dishwasher port sealed off. Until that plug is knocked out, the dishwasher cannot drain at all.
  • •Kinks where the hose passes through the cabinet wall. The hose gets pinched when the dishwasher is pushed in.
  • •An air gap that is clogged with food or grease and drips onto the counter every cycle.

A quick check you can do now

  1. Open the sink cabinet and follow the dishwasher drain hose from the cabinet side to the drain.
  2. Look for the highest point. It should be close to the underside of the counter, or at an air gap on the sink deck.
  3. Make sure it is secured with a clip or strap, not just resting there.
  4. If you have an air gap, pop the cap off and check for debris.

When drainage still is not right

If the hose is routed correctly but you find standing water in the tub, a gurgling sink during the cycle, or sink water appearing in the dishwasher, the issue may be a clogged filter, a failing drain pump or a partially blocked kitchen drain. Our dishwasher repair technicians can track it down when you book a visit. If you are in the middle of a replacement, our guide to measuring the opening for a new dishwasher covers the other installation details.

Want a Technician to Look at It?

We diagnose in your Columbus-area home and agree on the price before any repair begins.

More From Our Blog

CallBook