A freestanding electric range draws more power than almost anything else in a kitchen, so it needs its own 240-volt circuit sized to the appliance. The kilowatt rating on the range's rating plate drives everything else: breaker size, wire size, cord rating and receptacle. The installation manual for your model lists the exact requirements.
Start with the rating plate
The plate is usually behind the storage drawer, on the oven frame or under the cooktop. Note:
- •The kW rating at 240 volts (and at 208 volts, if listed).
- •The voltage, usually 120/240 for single-family homes. Some apartment buildings supply 120/208, and the range has to be rated for that.
- •The recommended circuit size if listed.
Manufacturers translate the kW rating into a circuit size in their manuals. Most residential ranges land on a 40- or 50-amp circuit, and larger ranges with more elements or a second oven often need 50 amps.
Matching the pieces
| Part | What has to match |
|---|---|
| Breaker | Double-pole, sized per the manual (commonly 40 or 50 amps) |
| Wire | Sized for the breaker, per the electrical code |
| Receptacle | NEMA 14-50R for 4-wire, or 10-50R on older 3-wire circuits |
| Cord | Rated at least for the circuit amperage, with the same wire count as the receptacle |
A cord rated below the breaker is a problem. If the cord can overheat before the breaker trips, the breaker no longer protects it.
3-wire and 4-wire
As with dryers, older range circuits may be 3-wire (two hots and a neutral, with the cabinet bonded to neutral), while newer ones are 4-wire with a separate ground. The cord and the bonding strap at the range's terminal block must match the receptacle. The details are in our explanation of 3-wire and 4-wire dryer hookups, and the same logic applies.
Where the receptacle sits
Range manuals show a zone, usually low on the wall and toward one side, where the receptacle must be so the range can slide back flush. A receptacle placed too high or in the wrong spot keeps the range sticking out from the counter and can crush the plug. Check the new range's diagram against the existing receptacle before delivery day.
Cooktops and wall ovens
Built-in cooktops and wall ovens are usually hardwired through a junction box, often with a factory-attached flexible conduit. Each has its own circuit size in the manual, and a cooktop and wall oven together may be on one circuit or two depending on their ratings and local code. Induction cooktops often call for 40 or 50 amps depending on size.
Switching from gas to electric or induction
A gas range only needs a 120-volt outlet. Switching to electric or induction means a new 240-volt circuit, and that raises a question about the panel. Many mid-century homes in Upper Arlington, Worthington and Clintonville started with smaller electrical services, and a panel may not have room or capacity for a large new load. An electrician can do a load calculation and tell you whether an upgrade is needed. The old gas line should be capped by a licensed plumber or gas fitter.
Checks you can make
- Read the kW rating and voltage on the plate.
- Find the range breaker in your panel and read its size.
- Count the openings in the receptacle.
- Compare the receptacle location with the new range's diagram.
- For a cooktop, look in the cabinet below for the junction box.
Leave covers on and wiring alone.
Warning signs
- •A breaker that trips when the oven and several elements run together.
- •A warm or discolored receptacle or plug.
- •One side of the range working while the other does not, which can point to a lost leg of the 240-volt supply.
Receptacle, breaker and circuit work belongs to a licensed electrician. When the supply checks out and a burner or bake element still will not heat, our range repair technicians can diagnose the range itself. We also service electric cooktops and wall ovens.