Call or book
Range

How Much Space a Range Needs Above and Beside It

Cabinets above and beside a range must stay clear of burner heat. Learn the usual overhead clearance, how side clearances vary, and how to measure your kitchen.

TrueFix Columbus4 min read

Heat climbs. Every range and cooktop installation manual includes a clearance drawing showing how far wood cabinets, shelves and walls must stay from the cooking surface. Those figures matter most during a remodel or when a replacement range is larger than the old one, which happens often in older Columbus kitchens built around smaller appliances.

Above the cooking surface

The most consistent figure across manufacturers is the space between the cooktop and the underside of a combustible cabinet directly above it:

  • •30 inches is the common minimum for an unprotected wood or metal cabinet.
  • •24 inches is often allowed when the cabinet bottom is protected as the manual specifies, typically with fire-resistant board covered by sheet metal.
  • •When a range hood or over-the-range microwave sits above the range, its own installation manual sets the clearance instead.

Measure from the cooking surface, meaning the top of the grates on a gas range or the glass on a smooth top, not from the countertop.

Beside the range

Side clearances vary much more between models, so they are the number to check closely.

  • •Below countertop height: Freestanding and slide-in ranges are generally designed to sit tight against base cabinets.
  • •Above countertop height: Manuals specify a minimum distance from the range's edge to a side wall, tall pantry cabinet or other combustible surface. Depending on the model, this can be as little as an inch or several inches. Larger burners near the edge often need more.
  • •Upper cabinets beside the range: Manuals commonly call for at least 18 inches between the countertop and the bottom of the upper cabinets on either side, and limit how deep those cabinets can be, often 13 inches.

Why the numbers exist

  • •Cabinet finishes, glue and wood dry out and can scorch with repeated heat, well before anything catches fire.
  • •Reaching over hot burners to a low cabinet invites burns. Some manuals recommend a hood that projects past the cabinet bottoms when the space above is used for storage.
  • •A protected cabinet bottom spreads and reflects heat, which is why the overhead minimum drops when protection is added.

Measure your kitchen

  1. Measure from the cooking surface straight up to the bottom of the cabinet, hood or microwave above.
  2. Look at the cabinet bottom for factory heat protection. If there is none, use the unprotected figure.
  3. Measure from the range edge to the nearest wall or tall cabinet on each side, above counter height.
  4. Check the height from countertop to the underside of each neighboring upper cabinet.
  5. Note how far those cabinets project from the wall.
  6. If you are replacing the range, compare all of this with the new model's drawing before buying.

Where older Columbus kitchens get tight

Narrow galley kitchens in German Village and the Short North, and original mid-century kitchens in Upper Arlington and Worthington, were often laid out around 30-inch ranges with a wall close on one side. A 36-inch professional-style range in the same spot can run out of side clearance quickly. Moving a range to a new location means moving its gas line or 240-volt receptacle too.

Signs of a clearance problem

  • •Blistered, darkened or peeling finish on cabinet bottoms or the wall beside the range.
  • •Cabinet handles or knobs that get hot.
  • •A hood or microwave bottom that is uncomfortably hot after cooking.

Fixing it

A cabinetmaker or remodeling contractor can raise, shorten or protect the cabinets. Moving a range means a licensed electrician for the receptacle or a licensed plumber or gas fitter for the gas line. Adding a hood brings its own height and duct rules, covered in our hood height guidelines.

If a range is overheating its surroundings because a burner runs too hot or an oven thermostat has drifted, our range repair technicians can test it and quote the repair first. We work across Columbus, including older homes in German Village.

Want a Technician to Look at It?

We diagnose in your Columbus-area home and agree on the price before any repair begins.

More From Our Blog

CallBook