A range hood catches a rising plume of smoke, steam and grease. Hang it too low and it sits in the heat, gets greasy fast and bumps heads. Hang it too high and the plume spreads out before it reaches the filters. The hood's installation manual sets a minimum and maximum distance, and that is the number to follow.
Typical ranges by cooktop type
Manufacturers publish general guidance that individual manuals refine. Common figures from major brands look like this:
| Cooktop | Typical distance from cooking surface to hood bottom |
|---|---|
| Electric (radiant or coil) | About 20 to 24 inches |
| Gas | About 24 to 30 inches |
| Induction | Can be at the low end of the electric range |
| Any type | Usually no more than about 36 inches |
Professional-style gas ranges and some commercial-style hoods have higher minimums. Island hoods often have their own figures. Your hood's manual overrides these general numbers, and the range manual may set its own minimum as well.
Width matters as much as height
- •Match or exceed the cooktop's width with the hood.
- •A hood a few inches wider on each side catches plumes drifting off the outer burners, and many manufacturers recommend it.
- •Island hoods, with no wall behind them to guide air, benefit most from extra width.
Fitting the ceiling
Chimney and canopy hoods use a duct cover that comes in set lengths. Combine the hood's mounting height with the ceiling height to see whether the standard cover fits or you need an extension kit. Eight-foot ceilings in many subdivision homes and taller ceilings in newer large homes in New Albany or older homes in German Village can each fall outside a standard cover's range.
Measuring your setup
- Identify the cooktop type: gas, electric or induction.
- Find the installation manual for your hood and note its minimum and maximum mounting heights.
- Measure from the cooking surface (top of the grates for gas) to the hood's bottom edge.
- Compare hood width with cooktop width.
- For chimney hoods, measure floor-to-ceiling height and check it against the duct cover range.
- If the space above the range holds an over-the-range microwave instead, follow its rules; see over-the-range microwave mounting height.
What goes wrong at the wrong height
- •Too low: Filters and the hood underside get very hot. Grease bakes on, and people hit their heads.
- •Too high: Smoke escapes into the room and smoke alarms trip more easily.
- •Too narrow: Front and outer burners are not covered.
- •Too close to cabinets: Check the range's clearance drawing as well; see cabinet clearance around a range.
Makeup air for powerful hoods
Codes based on the IRC generally require makeup air for kitchen exhaust hoods rated above 400 cubic feet per minute, so the house does not go into negative pressure. In a tight modern home, a large hood without makeup air can pull air back down chimneys or flues, which is a concern with gas appliances. Ask your local building department what applies before buying a high-airflow hood.
Who handles the work
The hood needs power, typically a 120-volt circuit, which a licensed electrician should provide if it is not already in place. Running duct through a wall, ceiling or roof is contractor work. Mounting the hood itself follows the manual's hardware and stud requirements.
Height is one half of hood performance and duct size is the other; read sizing the duct behind a hood next. If your hood's fan, lights or controls fail, or the range below has a heating problem, our range repair team can take a look and give you a price before starting.