Many Columbus-area homes have natural gas service, so gas dryers are common, especially in basement laundries. A gas dryer still needs a vent and an ordinary outlet, but it adds a fuel line and a burner, which brings more rules. The installation manual for your model sets the details; the points below are what those manuals and fuel gas codes generally cover.
Gas supply
- •Fuel type: Most gas dryers ship set for natural gas. Propane (LP) requires a conversion kit and must be done by a qualified technician. The rating plate shows which fuel the dryer is set for.
- •Pipe size: Manuals typically call for a supply line sized for the dryer's burner, often 1/2-inch pipe to the area. Smaller tubing may be allowed only on short runs and only where code and the gas supplier permit it.
- •Shutoff valve: An accessible manual shutoff valve must be installed for the dryer, in the same room and within a short distance of it. Many manuals and fuel gas codes use 6 feet as the limit. You should be able to reach it without moving the dryer.
- •Connector: A new, design-certified flexible appliance connector between the valve and the dryer. Do not reuse an old connector from a previous appliance.
- •Thread sealant: Use a compound rated for the fuel, as the manual specifies.
- •Leak check: After connection, every joint is checked for leaks with a leak-detection solution, never a flame.
Power
A gas dryer runs its motor, controls and igniter on 120 volts. It needs a grounded three-prong outlet, and many manuals call for a separate 15- or 20-amp circuit. No adapters or extension cords.
Venting
A gas dryer produces combustion products along with moist air, so its vent is even more important than an electric dryer's. The same length limits apply: rigid metal duct, a short listed transition, and termination outdoors. Never vent a gas dryer indoors. Our post on measuring dryer vent runs and elbows walks through the math.
Where it can go
- •Closets: Manuals generally prohibit other fuel-burning appliances in the same closet and may require door openings for combustion air.
- •Garages: Codes based on the IRC require appliances with an ignition source in a garage to be raised so the burner sits at least 18 inches above the floor, unless the appliance is listed as resistant to flammable vapor ignition. Gasoline vapor is heavier than air and settles low.
- •Near the water heater or furnace: In a typical Columbus basement, the dryer often shares the room with both. That is fine in an open room with enough combustion air, but the room should not be closed up tightly.
Checks you can do
- Read the rating plate to confirm the fuel type.
- Find the dryer's shutoff valve. The handle is open when it lines up with the pipe.
- Look at the connector for kinks, crushing or corrosion.
- Confirm a grounded outlet with no adapter.
- Make sure a working carbon monoxide alarm is installed on that level of the home.
Do not loosen fittings or try to adjust the burner yourself.
Warning signs
- •A gas smell near the dryer.
- •A yellow, lazy or noisy flame through the burner window.
- •Soot around the burner or vent hood.
- •Headaches or nausea in the household when the dryer runs.
If you smell gas, leave the house without operating switches or unplugging anything, and call your gas utility or 911 from outside.
Licensed work
Connecting, moving or disconnecting a gas dryer, installing a shutoff valve and running new gas pipe are jobs for a licensed plumber or gas fitter, as your local building department requires. LP conversion belongs to a qualified technician.
When a correctly installed gas dryer tumbles but will not heat, the usual suspects are the igniter, gas valve coils, flame sensor or thermal fuse. Our technicians work on gas dryers from most major brands, including Whirlpool and others. To book a diagnosis, use the gas and electric dryer repair page.