Maytag Cooktop
Repairing Maytag Gas and Electric Cooktops
Built-in cooktops sit flush in the counter with no oven beneath them, so when a Maytag cooktop acts up it usually comes down to a burner, an element, or the switch or valve that controls it. Columbus-area kitchens have plenty of both gas and electric Maytag cooktops, and the good news is that each burner is largely its own small system, so one dead zone rarely means the whole unit is finished.
Prefer not to call? The form takes about a minute.
Maytag cooktops come out of the Whirlpool Corporation family, which has owned the brand since 2006. Spark modules, sealed burner parts, infinite switches and radiant elements are shared with Whirlpool and KitchenAid units, so even a cooktop that has been in the counter for years can usually be fixed.
Gas Maytag cooktops
Maytag's sealed gas burners use a cap that sits on a base with an electrode beside it. Lift the cap to clean it and set it back a little crooked, and the flame will light unevenly or not at all. A boil-over that soaks the electrode causes nonstop clicking, often on every burner at once, because the spark switches on all burners are wired to one module. Let the burner dry for a day before assuming the module has failed.
A flame that is weak on every burner points toward the supply or the regulator. A yellow, lazy flame on a single burner usually means its ports are partly blocked or the cap is out of position.
Electric Maytag cooktops
Radiant glass
Under the glass, each radiant element is controlled by an infinite switch that cycles power on and off. An element that only heats on high, or never shuts off, usually has a failed switch rather than a failed element. A crack in the glass is a stop-using-it problem; the top is replaced as a panel.
Coil tops: Maytag cooktop
On coil models, swap a suspect element into a different burner. If it heats there, the problem is the receptacle or the switch, not the coil.
When it needs a professional: Maytag cooktop
- A gas burner still will not light after it has dried and the cap is seated
- Clicking that continues with every knob turned off
- An element that stays on with the knob off
- Any smell of gas, or a cracked glass top
Maytag Cooktop Repair Questions
Straight answers to what Columbus homeowners usually ask before booking. If your question is not here, send it with your booking request and we will answer it.
Still have questions?
Reach us by phone or book online. We cover Columbus and nearby communities in Franklin, Delaware, Fairfield, Licking, Union, Madison and Pickaway counties.
Yes. On most Maytag gas cooktops every electrode sparks when any burner is lit. It is only a problem if the clicking keeps going after the flame catches, or with all knobs off.
Almost always the infinite switch for that element. It is a common and fairly contained repair.
The glass itself cannot be patched, but the top panel can often be replaced if it is still available for your model. Stop using the cooktop until then.
Cooktop problems in general
Faults any brand can have, the symptom most often misread, and safe checks to try first
Cooktop Repair for Related Brands
Makers that share a platform or a service tier with Maytag